MORE INFO ABOUT TEQTON?
Contact Ole Skov for questions and guidance on our products and available certifications
The technical specifications are crucial to how a concrete floor is designed and how it performs in practice. Here you’ll find the key information on thickness, load-bearing capacity, flatness, shrinkage and production.
A complete Teqbase + Teqplan system has a standard total thickness of approximately 200 mm, with Teqbase as the load-bearing layer and Teqplan as a thin wear layer on top. The thickness can be increased for extreme loads or difficult ground conditions, and should always be designed on the basis of the project’s load and usage data.
Teqbase is designed for distributed loads of up to 200 kN/m² and point loads of up to 100 kN on a 0.1 × 0.1 m area. For special loads and uncertain ground conditions, we recommend a geotechnical survey, as the floor’s performance always depends on the underlying ground.
In practice, this means the floor can handle heavy racking in high-bay warehouses, fully loaded pallets with high rack leg loads, counterbalance forklifts, narrow aisle trucks and the point loads from AutoStore grid feet. We always carry out a project-specific calculation before recommending thickness and reinforcement.
As standard, Teqbase is laid in accordance with HUS AMA table 43.DC/-1, class B. For narrow aisle warehouses, high-bay warehouses, AutoStore facilities and AGV traffic, Teqplan can be laid to considerably stricter flatness requirements. We adapt the specification to the forklift supplier’s FM classification and the automation supplier’s requirements.
In practice, this means we can meet the flatness requirements for very narrow aisle (VNA) trucks, crane-served and high-bay warehouses, and AutoStore grids. Tell us which truck type, storage height and automation equipment you are planning, and we will design the floor to the exact tolerances required.
The polymer-reinforced concrete in Teqplan is formulated so that it does not shrink in the same way as traditional concrete. The binder and the dispersion create a dense, stable structure that does not build up shrinkage stresses, which is why joints are unnecessary, even across several thousand square metres.
We have used this technology in Sweden since 2001, and our oldest floors still sit tight against walls and columns after more than 20 years. This is one of the main reasons why major companies such as Lidl, Schenker, PostNord and Biltema have chosen the system.
BThe concrete is produced in Teqton’s mobile mixing plants directly on site, which minimises transport and ensures the right consistency. The paving machines are purpose-built and laser-guided to meet the tolerance requirements for jointless floors.
MORE INFO ABOUT TEQTON?
Contact Ole Skov for questions and guidance on our products and available certifications